Brief Summary Of Main Functions; Reverse The Direction Of The Scene; Fade Time; Tap Sync Button - Chauvet TFX-48CON Technical Reference Manual

O P E R A T I N G I N S T R U C T I O N S

Brief Summary of Main Functions

Reverse the direction of the scene

1. Reverse the direction of all the scenes. Press the ALL REV Button, all the scenes should change their directions.
2. Reverse the chasing direction of all the programs with speed control: Press the Chase Rev Button.
3. Reverse the chasing direction of all the programs with standard beat: Press the Beat Rev Button.
4. Reverse chasing direction of any program: Press and hold down the Rec One Button, then press down the Flash
Button corresponding to your desired program and release together.

Fade Time

1. The amount of time it will take for the dimmer to go from zero output to maximum output, and vice verse.
2. Fade time is adjusted through the Fade Time Slider, which varies from instant to 10 mimutes.

Tap Sync Button

1. The Tap Sync button is used to set and synchronize the chase rate (the rate at which all scenes will sequence) by
tapping the button several times. The chase rate will synchronize to the time of the last two taps. The LED above
the Step Button will flash at the new chase rate. The chase rate may be set anytime whether or not a program is
running.
2. Tap Sync will override any previous setting of the speed slider control until the slider is moved again.
3. Use of Tap Sync in setting a standard beat is the same with speed control slider.

Master Slider

Master Slider control provides proportion level control over all channels and scenes with the exception of the Flash
Buttons. For example: Whenever the Master slider control is at minimum all stage outputs will be at zero except for any
resulting from a Flash Button or FULL ON Button. If the Master is at 50%, all outputs will be at only 50% of the setting of
current channel or scenes except for any resulting from a Flash Button or FULL ON Button. If the Master is at full all
outputs will follow the unit setting. Master A always controls outputs of channels. Master B controls program or a scene
except in Double Press Mode.

Single Mode

1. All programs will run in sequential order starting in the order of program number.
2. The Segment Display will read the running program number.
3. All programs will be controlled by the same Speed Slider.
4. Press the MODE SELECT BUTTON and select "CHNS
5. Press the PARK BUTTON to select SINGLE CHASE MODE. A red LED will indicate this selection.

Mix Mode

1. Will run all programs synchronously.
2. All programs can be controlled by the same SLIDER SPEED, or each programs speed may be controlled
individually. (See Speed Setting).
3. Press the MODE SELECT BUTTON and select "CHNS
4. Press the PARK BUTTON to select MIX CHASE MODE. A yellow LED will indicate this selection.

Dimmer Display

1. The 3-Digit Segment Display is used to display intensity percentage or absolute DMX value.
2. To change between percentage and absolute value: Press and hold the Shift Button. While holding down the Shift
button, press the 5 or 0-255 Button to switch between percentage and absolute values.
TFX-48C Users Manual Version 2.03
SCENES".
SCENES".
18