Programming The Immobilizer System - PIAGGIO MP3 300 hpe 2020 Manual

Go directly to an Authorised Service Centre, bringing the MASTER key «A» and all
of the service keys «B» in your possession.
Service key codes not presented during the new storage procedure are cancelled from
the memory. Any service key that is lost will therefore be unable to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
WHEN OWNERSHIP OF THE VEHICLE PASSES FROM ONE PERSON TO AN-
OTHER, THE NEW OWNER MUST TAKE POSSESSION OF THE MASTER KEY
(AS WELL AS ALL THE OTHER KEYS) AND THE «CODE CARD».

Programming the immobilizer system (01_44)

Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
IZER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to "RUN".
PROCEDURE START
Insert the «MASTER» key «A» into the ignition switch (in «OFF») and turn it to
«ON». After 1 - 3 seconds, turn the key to «OFF » again and pull it out.
INTERMEDIATE PHASE
After removing the «MASTER» key «A», insert the key «B» to be programmed within
10 seconds and turn it to the «ON» position immediately. After 1 - 3 seconds, turn the
40