Programming The Immobilizer System - PIAGGIO xevo 250IE User Manual

lock, provided that the safety system recognises the code transmitted by the key. If
the code is not recognised, turn the key first to "OFF" and then to "ON"; if the lock
cannot be disabled, try with the other key supplied (red-coloured). If the engine cannot
be started, contact an Authorised Service Centre, which is provided with the elec-
tronic equipment required to detect and repair the system.
When additional keys are required, please note that data storage (up to 7 keys max.)
must be done on all keys, both new and existing ones.
Take the red-handgrip key and all the black keys supplied to an Authorised Service
Centre.
The codes of keys not submitted for the new storage procedure are deleted from the
memory. Any lost keys will therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED BY
THE SYSTEM CONTROL UNIT.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
IF OWNERSHIP OF THE VEHICLE IS TRANSFERRED, THE RED-HANDGRIP KEY
(AS WELL AS THE OTHER KEYS) AND THE "CODE CARD" MUST ALSO BE
TRANSFERRED TO THE NEW OWNER.

Programming the immobilizer system

Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
IZER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to «RUN».
Procedure start - red key
Insert the red-handgrip key in the switch key (in "OFF" position) and turn it to "ON".
After 1 - 3 seconds, turn the key to "OFF" again and pull it out.
19