Table of Contents
Advertisement
TO CHANGE TH E CHANN ELS SETTING:
1)
Press the <MENU> button.
2)
Scroll up or down until <8-Channels> is displayed.
3)
Press <ENTER>.
4)
Press up or down until <select: Basic> or <select: Advanced> is displayed. Basic uses 9
channels, Advanced uses 12 channels.
5)
Press <ENTER>.
Service Functions
T O R ES E T T H E F I XTU R E:
1)
Press the <MENU> button.
2)
Scroll up or down until <2-Reset> is displayed.
3)
Press <ENTER>.
4)
Press up or down until <select: Yes> is displayed.
5)
Press <ENTER>.
TO CHANGE TH E D ISPLA Y BACKLIGHT:
1)
Press the <MENU> button.
2)
Scroll up or down until <4-Display> is displayed.
3)
Press <ENTER>.
4)
Press up or down until <select: 60 close> or <select: Bright> is displayed. 60 close turns the
backlight off after 60 seconds; Bright leaves the backlight on always.
5)
Press <ENTER>.
Operation
Stand-Alone Mode (Sound-Active, Auto Mode):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode.
1)
Press the <MENU> button.
2)
Scroll up or down until <3-Operation> is displayed.
3)
Press <ENTER>.
4)
Press up or down until <select: Auto1>, <select: Auto2>, <select: Music1>, <select:
Music1>, or <select: Random> is displayed.
5)
Press <ENTER>.
6)
The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode, or the unit will auto change in Auto Mode. In Random mode, the unit will periodically
change between auto and sound-active modes.
Q-Spot 200 User Manual
17
9/5/2007 2:59 PM
Advertisement
Table of Contents
