Advertisement
Quick Links
Guilin Feiyu Technology Incorporated Company
G360 Gimbal Firmware Upgrade
Manual For Mac OSX
Attention
1.Please put the battery in before firmware upgrade.
2.The upgrade software and USB driver are compatible with the Mac OSX.
3.Please do the operations step by step strictly.
4.If you want to check current firmware version,please execute step 1-7.
Steps
1. Download the latest firmware ,update software and the USB driver from
our official website:www.feiyu-tech.com, Unzip them for further usage.
2.Double click on " USB Driver for Mac.dmg " to get " Silicon Labs VCP
Driver.pkg" .Double click it to install the USB driver,and finish it step by step .
3.Please put the battery in, and refer the following connection diagram,
connect the USB cable with USB port of Mac and the gimbal.
The indicator on the handle of gimbal is solid red now.
Please keep the gimbal off until step 7.
Guilin Feiyu Technology Incorporated Company
www.feiyu-tech.com
service@feiyu-tech.com
- 1 -
Advertisement
Related Manuals for FeiYu Tech G360
Summary of Contents for FeiYu Tech G360
- Page 1 Guilin Feiyu Technology Incorporated Company G360 Gimbal Firmware Upgrade Manual For Mac OSX Attention 1.Please put the battery in before firmware upgrade. 2.The upgrade software and USB driver are compatible with the Mac OSX. 3.Please do the operations step by step strictly.
- Page 2 Guilin Feiyu Technology Incorporated Company 4. Check the USB port by choosing “About This Mac”----”System Report” --- “USB”, and check whether “CP2102 USB to UART bridge controller” is in the hub list. 5. Double click on “Update for 3Axis” to run the update software.Please give a permission in System Preferences-Security&Privacy because the program isn’t downloaded from APP Store,and you have to run it with your permission for the first time.
- Page 3 Guilin Feiyu Technology Incorporated Company 6.The software interface is shown as the following picture. Select “cu.SLAB_USBtoUART” and the baud rate as 115200, then click on “OPEN COM”. 7. Long press the function button, The connection between the gimbal and Mac will be established automatically, The connection status and the current version show up(For example, “LINK OK! VERSION 1.
- Page 4 Guilin Feiyu Technology Incorporated Company the power is ready and the connection is done. (Tips: If you can’t see the indicator alternately flashing blue and red, please long press the function button for 2 seconds again.) 8.Click on “OPEN FILE” button and choose right firmware for the gimbal， then click“UPDATE START”to start updating.
- Page 5 Guilin Feiyu Technology Incorporated Company NO.1 “Link ok ”didn’t show up when pressing the function button. ① Please check whether tightly plug in USB cable with USB port, and the USB cable is right cable from our standard accessories. ② Please check whether keep the gimbal off until step7. ③...
- Page 6 Guilin Feiyu Technology Incorporated Company A: It happened because you didn’t hold the function button for enough time, and the power didn ’ t start well. When the power is ready , the indicator alternately flashes blue and red, if not, please keep holding the function button for 2 seconds.