Text Commands - Teleorigin RB900SG User Manual

Text commands

Below is a list of the available RB900SG modem text commands :
RB900SG GET FW VERSION - downloads the firmware version number of the
microcontroller
RB900SG GET IP - retrieves the IP address of the device
RB900SG GET RTCTIME - Get device time
RB900SG GET UPTIME - Gets the number of seconds
RB900SG CHECK - debug command
RB900SG RESET - resets the device
RB900SG TEST - device is sending data block
RB900SG TIME - Returns the current time in human form
RB900SG SM STOP - stops the GSM machine
RB900SG SM RESUME - resumes operation of the GSM state machine
RB900SG TM CONNECTED - informs the device about the connection via the teleorigin
manager
RB900SG LOG PRINT - Send all entries from the event log
RB900SG LOG FORMAT - removes all entries from the event log
PHONE ALLOWLIST ENABLE - turns allowlist on
PHONE ALLOWLIST DISABLE - turns off allowlish
PHONE ALLOWLIST STATUS - returns information whether allowlist is on or off
PHONE ALLOWLIST LIST - returns a list of numbers added to an allowlist
PHONE ALLOWLIST ADD xxxxxxxxx - adds a number to the allowlist
PHONE ALLOWLIST REMOVE xxxxxxxxx - removes the given number from the allowlist
PHONE ALLOWLIST CLEAR - removes all numbers from allowlist
PHONE ALLOWLIST SAVE - saves configuration
CONFIG SET APN name username password - sets apn
CONFIG GET APN name username passowrd - returns apn
CONFIG SET TCP PORTS data_port config_port - sets TCP ports
CONFIG GET TCP PORTS data_port config_port - returns TCP ports
CONFIG SET SIM PIN xxxx - sets the pin code of the sim card
CONFIG GET SIM PIN xxxx - returns the pin code of the sim card
CONFIG SET ANTENNA EXTERANAL/INTERNAL - sets the antenna to external or
internal
CONFIG GET ANTENNA EXTERANAL/INTERNAL- returns the antenna position
CONFIG SET PERIODIC REBOOT x - sets the periodic restart time, x = time in hours
CONFIG GET PERIODIC REBOOT x - returns periodic restart time, x = time in hours
CONFIG SET UART xxxx_abc - configures uart, xxxx = baudrate, a = start bits, b = parity,
c = stop bits
CONFIG GET UART xxxx_abc - Returns uart configuration
CONFIG SET TEXT INFO 1 data - sets text information, data = string
CONFIG GET TEXT INFO 1 data - returns text information, data = string
23