Teleorigin RB900SG User Manual page 18

• Connect the USB cable to the computer
• Configure the modem using the Teleorigin Manager program. It is recommended to
configure the modem without the SIM card inserted. Using the application, you can
save the PIN code of the SIM card to the internal memory and set the APN, APN
user name/password, change the antenna configuration (internal / external) and
TCP/IP listening port. The "Data" tab contains standard information about the
modem, such as signal strength, name of the network to which the modem is
logged in, modem firmware, IMEI serial number, GSM / LTE module model and
local IP address. If you cannot connect to the modem, follow these steps:
- check if the modem is connected to the computer via the USB interface
- check if the COM port number is correct
The detailed configuration procedure is described in the "Teleorigin Manager User Manual"
document.
• Disconnect the USB cable after setting up the device.
• Screw the GSM / LTE antenna on if an external antenna is to be used.
•
Remove the SIM card tray by pressing the yellow button as shown in the picture
below.
• Insert your SIM card into drawer.
• Verify if SIM card fits in the drawer properly (as shown below).
1
2
18