Bosch EPS 200 Operating Instructions Manual page 11

7.2.7 Checking toothed belt
The condition and tension of the toothed belt can only
be checked by Service or test personnel.
The toothed belt is to be replaced if checking reveals
the following signs of damage:
R
Toothed belt torn or not intact
R
Corroded wire inlays in toothed belt
R
Severely worn tooth flanks
7.2.8 Replacing flowmeter pipe filter
!
Before replacing the test oil, the EPS 200 must be
turned off and disconnected from the power supply.
!
The pipe filter contains oil-based substances and
substances which are a hazard to water. It must be
disposed of in accordance with the applicable regu-
lations.
Procedure:
1. Turn off the EPS 200.
2. Disconnect the EPS 200 from the power supply.
3. Unscrew the right housing cover bolts (8x).
4. Remove housing cover.
5. Use pliers to slide the hose clamps at the pipe filter
over the hose connections onto the hoses (Fig. 4, 1).
6. Detach the hoses from the pipe filter.
7. Slide the hoses onto the new pipe filter, paying at-
tention to the direction of flow of the pipe filter.
8. Use pliers to slide the hose clamps over the hose
connections of the pipe filter.
9. Re-insert the right side panel and screw on.
Fig. 4: Flowmeter pipe filter
Robert Bosch GmbH
Maintenance | EPS 200 | 11
7.� Spare and wearing parts
Description
Connection adapter M12
<)
Connection adapter M14
<)
Sealing plug
<)
Injection chamber
Clamping ring 17 mm
<)
Clamping ring 23 mm
<)
5 O-rings (9 x 3 mm)
<)
5 O-rings (7 x 4 mm)
<)
Hose line 1.5 m
(for draining the test oil tank) Ho-
se line (injection)
<)
Hose line (return)
<)
Stylus
Adapter lead set for injector testing
(1 684 465 574 and 1 684 465 575)
Intake filter for test oil tank (x3)
Flowmeter pipe filter
<)
Wearing parts
<)
EPS 200 | 11 | 11 en
Order number
1 687 010 170
1 682 312 042
1 687 010 173
1 687 001 879
1 683 083 004
1 687 010 171
<)
1 685 431 015
<)
1 687 434 051
|
1 689 989 050 2009-03-17