Log Placement - Napoleon Fiberglow Series Installation And Operation Manual

4.2

log placement

WARNING
!
• Failure to position these logs in accordance with these diagrams or failure to use parts specifically approved
with this appliance may result in property damage or personal injury.
• Do not place glowing embers, charcoal embers, vermiculite or charcoal lumps on this burner.
Phazer logs, exclusive to Napoleon, provide a unique and realistic glowing effect that is different in every installa-
TM
tion. These logs are fuel specific. Do not interchange. Refer to the replacement parts list.
Failure to follow these log placement instructions may cause sooting.
Place the fibre burner
A.
cover onto the two locat-
ing studs screwed into the
pan burner.
Position the slotted
D.
cavities on the bottom of
log #6 onto the slotted
projections shown. The
charred face should be
facing in.
Place the end of log #5
G.
on the right end of log
#1. The fork in the log
should straddle the knot
on top of the log #2.
B. Place the rear log #1 onto
the locating studs on the
rear log support.
E. Position the bottom cavity
of log #3 onto the bridge
(top right corner of fibre
burner cover) as shown,
with the charred face
inward.
Log colours may vary. During the initial use of the appliance, the colours
will become more uniform as colour pigments burn in during the heat
activated curing process.
Positioning the logs improperly will cause flame impingement and car-
boning.
Blocked burner ports can cause an incorrect flame pattern, carbon de-
posits and delayed ignition. Phazer
flame. Use only certified Phazer
dealer/distributor.
C. Position the holes on the
bottom of log #2 onto the
fibre embosses shown.
Position the pins on the
F.
bottom of log #4 into the
holes on the left end of
log #1 and the left end of
log #2.
logs glow when exposed to direct
TM
logs available from your authorized
TM
W415-0809 / D / 02.26.21
finishing
EN
13