Operating Instructions; Lighting Instructions; Match Lighting Instructions - Napoleon Fiberglow Series Installation And Operation Manual

Hide thumbs Also See for Fiberglow Series:

Installation and operation manual (48 pages)

Table Of Contents

Table of Contents

If the appliance is equipped with decorative glass doors, they must be fully opened when operating this gas log

set.

5.1

lighting instructions

Locate the pilot burner at the rear of the log set on the right

side.

Turn the gas control knob to the pilot setting

(on the left side of the appliance closest to the

back).

With the control knob depressed, push the

piezo igniter continuously until the pilot lights.

Hold the control knob in for 1 minute and

release. If the pilot goes out, repeat steps B and

Once the pilot stays burning, make certain

that the on / off switch is in the off position.

Turn the control knob counter-clockwise to the on

position.

Turn the on / off switch to the on position to ignite the burner. This

appliance must be isolated from the gas supply piping system by closing the individual manual shut off

valve during any pressure testing of the gas supply piping system at test pressure equal to or less than ½

psi (3.5 kPa).

If appliance shuts off, do not relight until you provide fresh air. If appliance keeps shutting off, have it serviced.

Keep burner and control compartment clean.

When lit for the first time, the appliance will emit a slight odour for a few hours. This is a normal temporary condi-

tion caused by the curing of the logs and the "burn-off" of internal paints and lubricants used in the manufacturing

process and will not occur again. Open a window to ventilate the room during this burn off period.

5.2

match lighting instructions

Remove any items necessary for easy access to the ODS (for example: logs, screens, etc.).

Follow appropriate lighting instructions found previously. Instead of pushing and releasing the piezo but-

ton, light a match and hold the flame to the end of the pilot and ignite the pilot.

After control knob has been released and pilot stays lit, reinstall any items that were removed for pilot

access.

Call a qualified service technician for repair or replacement of the piezo ignitor.

After extended periods of non-operation such as following a vacation or a warm weather season, the appliance

may emit a slight odour for a few hours. This is caused by dust particles burning off. In both cases, open a win-

dow to sufficiently ventilate the room.

Purge the gas line with the glass door open. Assure that a continuous gas flow is at the burner before closing the

door.