Table of Contents
Advertisement
UNPACKING & ASSEMBLY
When unpacking please check contents and advise your dealer immediately
if any parts are missing. The component parts of the machine are as follows.
The numbers in brackets refer to the parts diagram on page 15.
INVENTORY
1 x Collector Support (35)
1 x Collector Body & Motor (11 & 18)
1 x Collector (23)
1 x Base Plate (4)
4 x Castors (1)
1 x Cloth Filter Bag (25)
1 x Cloth Dust Bag (24)
1 x Gasket (22)
2 x Bag Support Rods (31)
1 x Adaptor (37)
1 x Fittings Kit
TOOLS REQUIRED
• Phillips screwdriver
• Flat-bladed screwdriver
• 8mm spanner
• 10mm spanner
• 13mm spanner
ASSEMBLY
To assemble your Dust Collector
proceed as follows:
1. Lay components out neatly.
2. Place the base plate (4), upside down and fit the four castors (1), using
screws, washers and nuts supplied. Fit all screws etc finger tight only at first.
Once all screws are in place, proceed to tighten them using a screwdriver
and spanner. (DO NOT OVERTIGHTEN).
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
6
Advertisement
Table of Contents
