Table of Contents
Advertisement
5. CONNECTING THE CONNECTOR
1. Connect the battery connector to the machine connector.
2. Reassemble all the elements.
ATTENTION: This process must be carried out by qualified personnel. The
incorrect or imperfect connection of the cables to the connector can seriously
harm people and damage objects
6. BATTERY TYPE
To power the machine it is necessary to use:
sealed traction batteries with gas recombination or gel technology.
OTHER TYPES MUST NOT BE USED.
The batteries must meet the requirements laid out in the norms: CEI EN 60254-1:2005-12
(CEI 21-5) + CEI EN 60254-2:2008-06 (CEI 21-7)
Every battery consists of DIN-type elements connected in series and providing the clamps with a power
of 12 V. You are advised to use batteries with an electric capacity of 65 Ah (C5)
7. BATTERY MAINTENANCE AND DISPOSAL
For maintenance and recharging, respect the instructions provided by the battery manufacturer.
Particular attention must be paid when choosing the battery charger, if not supplied, since there are
different kinds according to the type and capacity of the battery.
When the battery reaches the end of its working life, it must be disconnected by expert, trained
personnel, then lifted (using the grips and suitable lifting devices) to remove it from the battery
compartment. EXHAUSTED BATTERIES ARE CLASSIFIED AS DANGEROUS WASTE AND MUST BE
CONSIGNED TO THE AUTHORISED BODIES FOR CORRECT DISPOSAL.
Proceed as follows when the battery is dead:
1. Disconnect the quick connector and remove the solution tank.
2. Open the battery compartment and disconnect the connector.
Remove the battery by using suitable devices, lifting it with the provided handles.
ATTENTION: users are advised to always wear protective gloves, to avoid the
risk of serious injury to hands.
ATTENTION: you are advised to only lift and move the batteries with lifting
and transportation means suitable for the specific weight and size
PREPARATION OF THE MACHINE
11
Advertisement
Table of Contents
