In Built-In Installation; Water Line Connection - White-Westinghouse WR 747 SS User Manual

In built-in installation;

Fixing pin and the joints are used in Built-in version. The sequence of the assembly and
installation drawing are located below.
• Place the refrigerator in furniture which is built in special dimensions. The dimensions
can be found in page 9.
• Open the upper compartment cover.
• Put the fixed pins in appropriate holes and use the washers for tolerating gaps.
• Fasten the fixing pins to the furniture with using D4X20 Screws
Fixing pin
Built-in Installation
Important note: Be sure the levelling is correct done before screwing.

Water line connection

¼ '' mm plastic tubing is connected to the ice maker with a preassembled
¼ '' check valve connection at the end of the tube. Check valve is located behind the kick plate.
First, PEX tubing must be cut evenly with using tubing cutter for proper even cut to ensure
that to eliminate any leakages. Next, safety clips should be removed from the open end of
the check valve. Then the tubing must be inserted firmly to the check valve. Finally safety
clips should be inserted onto the check valve again.
To prevent leaks, all connections should be checked.
Important note: Before making any connection please make sure the water tubing is clean
with using some water to remove debris which may be present in the tube.
Important note: Water filtration system can be bypassed by removing the filter (see page
32); in case reverse osmosis system or any in-house filtration is used. Filter housing has an
automated bypass system.
Detail A
Lag screw
EN -18-
Detail B
Fixing
pin
Lag screw