Installation; Cable Entrance; Electrical Connections; Warranty - Seitron TAG02M Manual

INSTALLATION

ELECTRICAL CONNECTIONS

5
RESET
6
7
230V
8
STAGE
I
9
10
STAGE
II
11
12
13
WARNING
- To adjust properly room temperature, install the remote sensor far from heat sources, airstreams or
particularly cold walls (thermal bridges).
- The remote sensor must be installed at approximately 1,5 m above the floor.
- Connect the device to mains power with an omnipolar switch complying with the current standards and
with contacts break distance of at least 3 mm in each pole.
- Installation and electrical wirings of this appliance must be made by qualified technicians and in compliance
with the current standards.
- Before wiring the appliance be sure to turn the mains power off.

WARRANTY

n the view of a constant development of their products, the manufacturer reserves the right for changing technical data and
features without prior notice.
The consumer is guaranteed against any lack of conformity according to the European Directive 1999/44/EC as well as to the
manufacturer's document about the warranty policy.
The full text of warranty is available on request from the seller.

CABLE ENTRANCE

12
L 230V
1
50 60Hz
N
2
REMOTE
SENSOR
3
4
TAG02M0000SE 035670 161120