Installation - Seitron FREETIME PLUS Manual

OVERVIEW
This device is an electronic daily chronostat with an ample backlit
display for showing the room temperature reading or current time,
as desired.
The room temperature can be set in the Heating or Cooling mode on
two different levels: Comfort and Economy.
In addition, the device offers the option of setting the Antifreeze
temperature and adjusting the Offset value on the internal sensor.

INSTALLATION

The device is designed to be installed in a standard recess (or wall)
mounted junction box with two or three modules or else directly on
the wall using the screw anchors provided.
To install the device carry out the following steps:
- Release the wall plate fitted under the base of the timer thermostat
as shown in Fig. 2.
- Fix the plate directly to the wall or a 3-module flush connection box
using the two screw fastening holes with centres spaced 60 mm or
85 mm apart (Fig. 3), taking care to thread the wires through the
slot as shown in Fig. 3.
- Make the electrical connections following the connection layout
shown in Fig. 4.
- Bring the timer thermostat near the wall plate, first matching up
the teeth on the base with the holes in the plate, and then pressing
downward on the device until the plastic teeth snap into place; then fix
the chronostat body to the wall mount plate through the two screws
supplied which must be mounted in the battery holder (Fig. 3).
- Insert the batteries in the battery compartment (M in Fig. 1); see
paragraph ' HOW TO INSERT/REPLACE THE BATTERIES '.
The chronostat must be positioned about 1.5 m above floor
level, away from sources of heat, doors and windows.
STARTING
When operating the device for the first time:
Fit the batteries into the compartment provided, observing proper
polarity (Fig. 1). Reset the device by inserting a pointed implement
through the hole provided (L on Fig. 1); DO NOT USE NEEDLES.
There are three control buttons beneath the lower cover 3:
'OK': Programming/Time/Confirm (I on Fig. 1);
'': Forward (G on Fig. 1);
'': Back (H on Fig. 1);
Setting the current time
To set the timer thermostat clock carry out the following steps:
1. Open the cover of the battery compartment.
2. Press the ' OK ' button for at least 2 seconds.
3. Set the hour using buttons '  ' and '  '.
4. Confirm with ' OK '.
5. Set the minutes using buttons '  ' and '  '
6. Confirm with ' OK '.
Setting the Heating / Cooling modes
Pressing button '  ' for at least 4 seconds will activate the 'Heating'
function and the ' f ' symbol will appear flashing on the display.
Pressing button '  ' for at least 4 seconds will instead activate
the 'Cooling' function and the ' x ' symbol will appear flashing on
the display.
13