Page 9
SIReB Basic RDS A RDS E SIReUB1 SIReRTX SIReB1/B2/B1EC 230V~ (optional) ROOM Pot. Unit ID ACTUATOR SUPPLY SIReCC6XX L=2m (max 50 m) SIReCC6XX (max 10 m) SIReB1/B2/B1EC 230V~ ROOM Pot. Unit ID ACTUATOR SUPPLY SIReCC6XX (max 50 m) SIReB1/B2/B1EC 230V~ ROOM Pot.
Page 10
SIReB Basic RDS W SIReUB1 SD230 SIReRTX SIReB1/B2/B1EC 230V~ (optional) ROOM Pot. Unit ID ACTUATOR SUPPLY SIReCC6XX L=2m (max 50 m) L=1,5m SIReCC6XX (max 10 m) SD230 SIReB1/B2/B1EC 230V~ ROOM Pot. Unit ID ACTUATOR SUPPLY SIReCC6XX (max 50 m) SD230...
Page 11
Output charts water Supply water temperature: 80 °C Water temperature: 80/60 °C Room temperature: +18 °C Room temperature: +18 °C Outlet air temperature: +35 °C* Type Airflow Output Return Water Pressure Output* Outlet Water Pressure position water flow drop air temp. flow drop temp.
Page 12
42,0 0,56 50,8 26,4 30,0 0,32 17,6 3100 14,4 30,0 0,14 16,7 33,9 0,20 ) Recommended outlet air temperature for good comfort and optimized output. ) Nominal output at given supply and return water temperature. See www.frico.se for additional calculations.
Read these instructions carefully before the roof of the revolving door cannot take installation and use. Keep this manual for the weight, RDS can be mounted on a beam future reference. construction. Mounting brackets for beam The product may only be used as set out in included.
Note that the unit shall be preceded by a cleaning is necessary. The level of cleaning regulating valve, see Frico valve kit. can vary depending on local conditions. The water coil is connected on the side of the unit via DN25 (1’’), internal thread...
Page 16
Fan replacement Residual current circuit breaker (E) Fans are replaced through the bottom service When the installation is protected by means hatch. Alternatively the screws of the bottom of a residual current circuit breaker, which service hatch are slackened and the fans are trips when the appliance is connected, replaced through the top service hatch.