Cleaning; Storage - ADE KA 1801 Operating Instructions Manual

Cleaning

Electrical shock HAZARD
− Do not immerse the motor block and the power cord with power plug
in water or other liquids.
− Unplug the power cord from the mains outlet before cleaning the
device.
WARNING against injury
− The cross blade is very sharp. Be careful when inserting, cleaning, and
changing.
NOTE on material damage
− The filling tray, feed screw, screw body with the filling tube, perforated
discs, and fixing ring must not be cleaned in the dishwasher. These
parts are not dishwasher safe and their functionality may thus be
compromised. After cleaning, all parts (especially the perforated discs)
must be thoroughly dried out so as to prevent any rust film.
Housing
− Wipe the motor block with a slightly damp cloth, if necessary. Then, wipe it dry
thoroughly.
Accessories
1. Thoroughly clean the accessories in hot dishwashing water or in the dishwasher
(the filling tray, feed screw, screw body with the filling tube, perforated discs, and
fixing ring must not be cleaned in the dishwasher).
2. Wipe all parts dry thoroughly. After cleaning, all parts (especially the perforated
discs) must be thoroughly dried out so as to prevent any rust film.
3. Finally, check that all parts are really thoroughly cleaned and free of any stuck
leftovers.

Storage

1. Clean the device and accessories; see previous chapter.
2. Use the cable compartment under the motor block to wind the power cord.
3. Keep the device out of reach of children in a dry, frost-free place.
Mincer KA 1801
Cleaning
39