Chamberlain 41A6127 Owner's Manual

Chamberlain 41A6127 Owner's Manual

Three-button security+ 315 mhz control

Advertisement

Available languages

Available languages

Model 41A6127 Three-Button Security✚
Only for use with 315 MHz Security✚
and universal receivers that have an orange "learn" button.
Instructions Are Described and Illustrated Below
1. Press and release the
"learn" button. The learn
indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote.
3. Release the button when the light blinks.
It has learned the code.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the "learn" button until the
learn indicator light goes out (approximately
6 seconds). All previous codes are now
erased. Reprogram each remote or keyless
entry you wish to use.
114A3007
OWNER'S MANUAL
®
garage door openers
9
1
9
1
7
3
7
3
5
5
KG
KG
© 2004, Chamberlain Group Inc.
All Rights Reserved
315 MHz Control
®
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
CAUTION
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.

To Control the Opener Lights

NOTE: Not available with universal receiver.
With SECURITY✚
®
transmitters, a remote push button can be
programmed to operate the opener lights without opening
the door.
1. With the door closed, press and hold the remote button that
you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener lights
should turn on or off but the door should not move.

The Remote Control Batteries

WARNING
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
CAUTION
• If battery is swallowed, immediately notify doctor.
The lithium batteries should produce
power for up to 5 years. To replace,
pry open case with visor clip or
screwdriver, as shown. Insert
batteries positive side up (+).
Dispose of old batteries properly.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
1-800-528-9131
®
Battery
positive
side up (+)
Printed in Mexico

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 41A6127 and is the answer not in the manual?

Questions and answers

nick
April 26, 2025

garage door remote not working batter is good

1 comments:
Mr. Anderson
May 14, 2025

The Chamberlain garage door remote 41A6127 may not be working despite having a good battery due to weak signal strength or range issues. Some users report that older remotes only work when very close to the garage door, even with new batteries. In some cases, the remote may require reprogramming or may not be compatible with the opener due to age or model differences. Also, pointing the remote directly at the opener’s antenna may be necessary for a strong signal.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for Chamberlain 41A6127

  • Page 1 Model 41A6127 Three-Button Security✚ Only for use with 315 MHz Security✚ and universal receivers that have an orange “learn” button. Instructions Are Described and Illustrated Below 1. Press and release the “learn” button. The learn indicator light will glow steadily for 30 seconds.
  • Page 2 Modelo 41A6127 Control 315 MHz de Tres Botones Security✚ Para usarase con abre-puertas del garaje Security✚ receptores universal que tengan un botón anaranjado “Aprendizaje”. Las Instucciones se Describen e Ilustran Abajo 1. Oprima y suelte el botón “Aprendizaje”. La luz indicadora de este botón...

Table of Contents

Save PDF