Table of Contents
Advertisement
ADwin
10 ADwin-Gold-Boot
This option is only available in an ADwin-Gold-ENET.
ADwin-Gold-Boot starts a previously programmed application automatically
after power-up. After installation of this application an operation without com-
puter is possible.
With ADwin-Gold-Boot the following steps are executed after power-up:
– Loading the operating system
– Loading of the compiled processes, compiled by ADbasic (max. 10).
– Automatic starting of the process no. 10. Here you have also to program
the start of all other processes.
If you do not wish to work with the boot loader option:
– Boot the system after power-up and the previously saved processes are
disabled.
– After switching off and powering up anew, the boot loader option is
enabled again.
By programming the Flash-EEPROM without processes and only with the file
<ADwin9.btl> the system will only be booted after power-up, but no pro-
cesses can be executed.
With the installation of the ADwin Developer-Software from the supplied
ADwin CD-ROM, the utility program for the boot loader (ADethfl
matically copied. You should have a CDROM version 3.00.2735 or a later ver-
sion.
Use the program <ADethflash.exe> for an ADwin-Gold system with Ether-
net interface.
At standard installation you will find the program in the directory
<C:\ADwin\Tools\Ethernet Interface\...>.
You will find information about the boot loader with Ethernet interface in the
ADwin Driver Installation manual.
In combination with the Ethernet interface and boot loader you can write or read
out 2000 long or float values à 32-bit via ADbasic processes into/from the
Flash- EEPROM. A more detailed description can be found in the program
<ADethflash.exe> by clicking on "Info about eeprom support".
1. After execution this register will automatically be reset.
ADwin-Gold USB / ENET, manual version 3.8, October 2005
ADwin-Gold-Boot
Disable boot loader
1
ash) is auto-
Help for Ethernet
interface
2000 values you can
freely dispose of
43
Advertisement
Table of Contents
