Tpi And Abv Initialization; The Ignition Switch Is Turned On - KYMCO Movie S 125i Service Manual

5. Fi INJECTION SYSTEM
Adjust TP screw should not be allowed.
The best engine working condition had
already been adjusted by KYMCO, if any
change, maybe cause to engine problem.
Connect the PDA or KYMCO Fi diagnostic tool.
Choose the Data Analyze

The ignition switch is turned on

Starting engine till working temperature 80°C
Check if the ignition
malfunction.
If figure is over 20°C, you should adjust the air
bypass adjustment screw for 1~1.5 turns
(counterclockwise). Don't adjust the air bypass
adjustment screw over 1.5 turns.

TPI and ABV Initialization

After replacing the throttle body or engine
overhauled, the efficiency of air intake would be
changed, have to do the TPI/ABV initialization
process.
When the engine is started, turn off the ignition
switch first and then turn it on again (keep the
engine is off).
Use a test rod or wire clip short Reset (pink)
wire to short with negative of battery or the
earth of frame to reset TPI ABV.
After short, remove the test rod or wire clip.
Don't let them connected all the time.
Do not break the PVC sleeve of Reset wire.
5-23
advance data is
MOVIE S 125i
TP screw
23.25º