ABB NEXUS Series User Manual page 10

4.
Connect and configure devices using the RS485 ports.
Note: The RS485 voltage surge protector, order code
long.
Two of these parts are shipped with each
as described below.
Each RS485 cable must be plugged into a surge protector, and the protector plugged into one of the
Series device's RS485
Additional units can be ordered if required, in packs of two.
Note: Turn on the corresponding dip switches to enable the network bias and termination.
Note: After the NEXUS Series
©ABB 2021 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
NEXUS Series |
1S9NT106
NEXUS Series
ports:
device setup is complete, reinstall the dust covers on any unused ports.
Installation and configuration
, is approximately 20 mm (0.8") wide x 50 mm (20")
device and for warranty purposes must be installed
NEXUS
10