BMW HP4 RACE Rider's Manual page 80

6
ATTENTION
Component damage
78
Starting the engine with gear en-
gaged
The motorcycle is not
equipped with engine starting
suppression. Always engage
neutral gear when starting or
pull the clutch.
z
Engage neutral, or pull back
clutch lever if a gear is en-
gaged.
In the case of cold start or un-
der cold temperatures: Pull
back clutch lever.
Press KILL button 1.
Button engages.
Press START button 2.
NOTICE
The starting attempt is automati-
cally interrupted if battery voltage
is too low. Recharge the battery
before you attempt to start the
engine again, or use jumper ca-
bles and a donor battery to start.
More detailed information can
be found in the "Maintenance"
chapter under "Jump-starting".
Engine starts.
Pre-Ride-Check
After the ignition is switched on,
the instrument panel performs a
Pre-Ride-Check test to check the
warning lights and the tachome-
ter. Only start the engine if the
Pre-Ride-Check has been com-
pleted.
Phase 1
The LED band 1 lights up from
left to right.
The warning and indicator lights
2 light up from top to bottom.
The start screen appears in the
multifunction display 3.