The Depth Alarms; Setting Alarms; Set Shallow Alarm; Set Deep Alarm - Navman MULTI 100 User Manual

The Depth Alarms

The shallow water alarm sounds when the depth
falls below the selected value. The deep water
alarm sounds when the depth exceeds the
selected value. When an alarm is activated the
beeper will sound continuously and the bell
alarm symbol will flash.

Setting Alarms

Press the key to switch the alarm on or off.

Set Shallow Alarm

Press the and
alarm mode.
Use the and
Press the key to exit.
10
DEPTH
SPEED
DEPTH
SPEED
keys to enter shallow
keys to set alarm value.
DEPTH
SPEED

Set Deep Alarm

Press the and
mode.
Use the and
Press the key to exit.
Note:
When units are changed, the alarm
values are automatically recalculated.

Select Temperature Units

When the top section of the display is indicating
temperature, press and hold the
three seconds to change the units of measure
between °C and °F.

Select Depth Units

When the top section of the display is indicating
depth, press and hold the
seconds. The new unit of measure will be
displayed for three seconds.
Alternatively, when the bottom section of the
display is indicating depth, press and hold the
key for three seconds. The new unit of
measure will be displayed for three seconds.
Depth units can be selected in the following order;
metres, feet and fathoms.
keys to enter deep alarm
keys to set alarm value.
key for
key for three
NAVMAN M100 User Manual