Start-Up And Use; Starting The Dishwasher; Loading The Detergent - Hotpoint Ariston LV 460 Instruction Booklet

Start-up and use

Starting the dishwasher

EN
1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent (see below).
4. Load the racks (see Loading the racks) and shut
the door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are (see table of wash
cycles), by turning the knob clockwise.
6. After a few minutes the cycle start and the WASH
CYCLE PHASE indicator lights display the status
of the cycle:
Pre-wash, Wash, Rinse, Drying.
7. At the end of the cycle two short beeps
sound and the DRYING indicator light will flash.
8. Turn the knob anti-clokwise to RESET in order to
reset all the settings.
9. Switch off the appliance by pressing the ON/OFF
button, shut off the water tap and unplug the
appliance from the electricity socket.
10.Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
If a mistake was made during the wash cycle
selection process it is possible to change the cycle,
provided that it has only just begun: turn the knob
anti-clockwise until it reaches the RESET position.
After a few seconds one long beep
*
beeps , the WASH CYCLE PHASE indicator light will
switch off: select the new cycle.
Press the ON/OFF button and open the door, taking
care to avoid the escaping steam, and place the
crockery inside the dishwasher. Press the ON/OFF
button again: the cycle starts from the point at which
it was interrupted.
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts again
from the point at which it was interrupted once the
door has been shut or the electricity supply is
restored.
18

Loading the detergent

*
will
compartment A and close the cover; when it requires
*
and three short
2, place the second tablet at the bottom of the
appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
*
Washing detergent
Pre-wash detergent
1. Open cover C by pressing
D
button D.
A
B
2. Pour in the detergent after
consulting the Wash cycle table:
• for powder detergent use
compartments A and B
• for tablets, when the cycle
requires 1 tablet, place it in
C
Only available in selected models.