Rear Panel - OCI BDL800IR Instruction Manual

Filament, Wehnelt, Focus,
Grid2&3, and Screen
Beam Energy Control
Filament On/Off
Screen On/Off
Constant Beam Current On/Off
Shut Down
4.1.2

Rear Panel

Element
Beam Energy Remote Control
USB Connection
16 Chapter 4 Electronics
highlight a desired program and press Select to confirm.
The Save button saves the current displayed voltages and
the filament current.
Select any of these to be set by the Beam Energy Control
knob.
Turn knob to change value of the selected variable (see
above). If none of the above variables are selected, beam
energy will be changed. Press the knob to (de)activate a
beam energy ramp.
Turn filament current on and set it to a pre-set value, or turn
it off.
Turn screen voltage on and set it to a pre-set value, or turn it
off.
Turn constant current mode on/off. The controller will au-
tomatically adjust either the filament current or the Wehnelt
voltage to keep the beam current constant with a value tak-
en at the time when it was turned on.
Press and hold > 2 s to soft shutdown the unit.
Description
DB9 connector for remotely controlling beam
energy in the LEED mode.
USB port used to remotely control the unit