Getting Ready; Setting Up The Projector - Casio XJ-S33 User Manual

Setting Up the Projector

Locate the projector on a desk, table, or stand that is firm and level. Make sure to allow
sufficient space around the sides and back of the projector for proper ventilation.
The following illustrations show how the projector should be oriented for optimum projection
relative to the screen.
Viewed from Above
The center of the
projector's lens
should be aligned
with the horizontal
center of the screen.
You can place the projector on a surface that is angled up to 30 degrees upwards or
downwards during use. Never locate the projector on a surface that is angled more than 30
degrees, or angled at all to the left or right. Such conditions can cause the lamp to
explode or can shorten lamp life, and also creates the risk of malfunction.
The projector's auto keystone correction range is 0 to +30 degrees. If the surface you are
projecting onto is angled downwards from horizontal, use manual keystone correction (page
E-25) to correct the image.
Turn on the "High Altitude" setting on the setup menu when using the projector in a high
altitude (1,500 to 3,000 meters above sea level) area where air is thin. For details, see the
Userís Guide on the CD-ROM that comes with the projector.

Getting Ready

Screen
E-14
Viewed from the Side
Screen
Make sure the
projector is at a
right angle to the
screen.