Table of Contents
Advertisement
Service Info
General Info
The AutoSlant System requires very little maintenance, but there are a few procedures that will ensure the system continues
to work correctly for many years.
Before Each Day
• It is highly recommended that the sprayer friction pads are greased. This will ensure the boom is pivoting separately
from the sprayer.
It may be necessary to grease the friction pads multiple times throughout each day. Please refer to "Lubrication of the
Sprayer" on page 53.
• Ensure that there is a clean, dry foam disc inserted in each sensor. If it is clogged with dust or other debris, clean it as
described in "Cleaning Ultrasonic Height Sensors" on page 52.
• Inspect the foam disc insert in each sensor. If it is clogged with dust or other debris, clean it. When the foam is removed
from the sensor, it can be blown out with an air compressor. If necessary, replace the foam. The AutoSlant system must
always be operated with the foam disc insert in each height sensor.
At the End of the Season
• Remove the height sensors from the sprayer and store inside. Record the sensor serial numbers in "Sensor Setup" on
page 52 to ensure each height sensor is returned to its original location at the start of the next season.
• If necessary, contact your HARDI dealer to have the sensors recalibrated or repaired.
6 - Maintenance
51
Advertisement
Table of Contents
