Advertisement
Available languages
Available languages
STEP:1
As photo shown
1) in order to facilitate assembly, use one of the lager styroform set
under the Frame ( as photo shown)
2) Attach the front support with transportation wheels to the frame with
two bolts (#19) washers (#65) nuts (#20)
3) locking sleeves with tool and cover the nut with two caps (#21)。
STEP:2
As photo shown
1) In order to facilitate assembly, use one of the lager styroform set
under the Frame ( as photo shown)
2) Attach the rear support to the frame with two bolts (#19)
washers (#65) nuts #20)
3) locking sleeves with tool and cover the nut with two caps (#21)
STEP:3
As photo shown
1) place upright tube on top of a chair ( or by a second person to
assist holding) close to the main frame be facilitated to connect the cables.
2) check the direction of upright tube before connect the Top/Bottom
pre-assembled cables as photo shown.
3) fixing eight screws (#18) with finger locking first then tighten all firmly.
Note! tighten the two screws on the label "①" screw hold and
then locking up the rest of six screws.
STEP:4
1) Set both pedal tube (R#74/L#75) & plastic pedals(#52/#53)
on the floor, indentity the (R/L) match up left set (#74/#52) &
right set (#75/#53).
Note! the pedal has left/right label, check the diredtion of pedl
for front and foot protection edge of pedal as drawing shown)
2) lock up both pedals to the tube plate with screws(#22), nut (#20),
with tool socket & screw driver firmly ( as drawing showm)
Note! Three sets of holds on the tube plate, user may choice
one set to use, eash set will give one inch variation pedal
distance to select, make sure bothpedals select the same
location of holes
STEP:5
1) Frist, distinguish between the left/right pedal support tube
(note: check pedal support tube with left/right label)
2) Set both pedal support tube (#74K) to the main frame
as drawing shown first。
3) Insert long bushing (#82) to the axle on main frame (disc),
then inset both pedal trube (#74K), insert short bushing (#83)
washer (#1 7), secure each with M10 nylon lock nut (#12)
fully tighten up
4) cover the nut with end cap (#5)
JOYSPORT
www.joysport.nl7
FRONT SUPPORT (Front Stabilizer) Assy
REAR SUPPORT (Rear Stabilizer) ASSY.
UPRIGHT TUBE ASSY. TO THE FRAME
PEDAL ASSY.
PEDAL SUPPORT TUBE ASSY. (一)
NO
PARTS LIST
QUANTITY
#19
2
#65
2
#20
2
#21
2
NO
PARTS LIST
QUANTITY
#19
2
#65
2
#20
2
#21
2
NO
PARTS LIST
QUANTITY
#18
6
NO
PARTS LIST
QUANTITY
#22
8
#20
8
NO
PARTS LIST
QUANTITY
#5
2
#12
2
#17
2
#82
2
#83
2
7
Advertisement
