STEP:10
A photo shown
1) Connect cable comes out from console (#43) also cables from the upright tube
firmly.
Note: check & plug cables, same color to plug together, black color
can plug with black no need to select special plug.
2) Insert all plugged cables into the uprught tube, set console (#43) on the top of
upright tube, secure with for screws (E)
STEP:11
As photo shown
1) Set both pedal tube (#74/#75) & plastic pedals(#52) on the floor, There is no
difference between the left /right pedals (#52), secure both pedal (#52) to the
pedal tube assy.(#74/#75) with screw (#18) from the top.
Note! the pedal has left/right label, check the direction of pedal
for front and foot protection edge of pedal as drawing shown)
2) There is a stride location adjustable bar (#55) can set with 8 different locations
for the stride length, it has to set both left & right bar at the same location
( number shown on the plastic pedals)
Note! Three sets of holds on the tube plate, user may choice one
set to use, eash set will give one inch variation pedal
distance to select, make sure both pedasl select the same
location of holes
STEP:12
As photo shown
1) Plug the power cord with power adaptor (#34) into an appropriate outlet
IMPORTANT: The elliptical exerciser is not compatible with
GFCI‐equipped outlets.
2) The othe r end of the access hole in the rear of the base frame
Note! before plug in, please check the voltage specifications
on the label.
JOY SPORT
CONSOLE ASSEMBLY
PLASTIC PEDAL ASSY.
POWER ADAPTOR
NO
PARTS LIST
QUANTITY
E
4
NO
PARTS LIST QUANTITY
#18
8
NO
PARTS LIST
QUANTITY
#106
1
11