General Information; Safety Precautions - Lavorwash THERMIC 10 HW Manual

Translation of the original instructions

GENERAL INFORMATION

• This appliance's
userfriendliness
PROFESSIONAL use.
• The appliance can be used for washing surfaces
outdoors, whenever pressurised water is
required to remove dirt.
• With special optional accessories, it can be
used for foaming and sandingblasting, and for
washing with a rotary brush for application to
the gun.
> THECNICAL DATA
(see thecnical data plate)
SYMBOLS
WARNING: It is important to be
careful of the following items.
IMPORTANT
LOCKED
OPEN
IF PRESENT
warning do not touch
warning symbol : do not inhale
. .

SAFETY PRECAUTIONS

> WARNINGS
• 1) This manual has been drawn up for
THE USER. The instructions concerning
the motor are not those included in
this booklet, but those indicated in the
booklet written by the manufacturer.
2) Please carefully read the enclosed
instructions that
points about
installation, usage and maintenance.
performance
make it suitable
include important
the safety for
KEEP THIS BOOKLET HANDY FOR ANY
•
FURTHER INFORMATION.
and
3) This machine has only to be used for
for
the purpose for which it was specifically
designed. Any other use shall be
considered improper and, therefore,
dangerous. The manufacturer shall not be
held responsible for any damages caused
by improper, incorrect and irrational use.
• DO NOT ALLOW THE DEVICE TO BE
USED BY CHILDREN OR IRRESPONSIBLE
PEOPLE WITHOUT SURVEILLANCE.
4) The unit must continuously run
with water (approximately 30% higher
than the data stated in the technical
characteristics). Dry running will cause
serious damage to the seals.
5) Do not disassemble the unit or effect
any maintenance operations while the
unit is working.
6) Protect the unit against freezing.
Avoid storing the machine in cold places.
7) • Never let the machine work for
more than 1÷2 minutes with gun in closed
position. Over this time the temperature
of the re-cycled water wiIl increase
quickly and could risk damaging the
pump seals.
8) The pump is equipped with a thermal
release valve: in case of prolonged
operation with the gun closed and water
open, this valve protects the pump
against overheating.
9) When the unit is working do not use it
in a closed place where ventilation may
be insufficient and never cover the unit.
10) By no means use the machine
during thunderstorms or when it is
raining. Avoid to point the water jet to
the machine or to any electric part.
11) During operation wear suitable clothes
complying with
safety norms, and in any case make use
of protection glasses and antislip rubber
shoes.
12) Avoid to disperse polluting, noxious
and toxic substances in the environment.
13) Disconnect the equipment in the event
of breakdown or malfuncion. If any repair
is needed contact an Authorized Dealer
the
only and ask that only original spare
parts are used. Failing to observe the
EN
13