Advertisement
Quick Links
Advertisement
Related Manuals for MinimumRC Spacewalker V2
Summary of Contents for MinimumRC Spacewalker V2
- Page 1 Spacewalker V2 Assembly Instructions...
- Page 4 6. Fix steel landing gear with screw.
- Page 5 8. Use a ruler to push the crease along the dotted line.
- Page 10 18. When the balsa is too difficult to bend, wipe the outer surface with a wet cloth.
- Page 15 27. Install the hatch (not gluing it). 28. Sand the fuselage.
- Page 16 29. Insert the windshield fixing bar into the fixing hole of the fuselage and glue it from inside.
- Page 17 32. Make a hinge with tape.
- Page 19 36. Make a hinge with tape.
- Page 20 38. Install the magnets.
- Page 23 43. Use heat shrinkable tube to hold the wheels. Installation of the control horns.
- Page 24 Installation of the control horns. 46.Assemble the dummy engines.
- Page 27 Connect the pushrod clips & pushrods with heat shrinkable tube and fix them with glue.
- Page 28 Installation of the pushrods. Connect the pushrod clips & pushrods with heat shrinkable tube and fix them with glue.
- Page 29 Installation of the pushrods.
- Page 30 Installation of the receiver.
- Page 31 ·The amount of elevator, rudder and aileron is 5 mm for each side. Please adjust the rudder surface to the level before flight test. Explore the ultimate possibility of airplane kits MinimumRC.COM...
Need help?
Do you have a question about the Spacewalker V2 and is the answer not in the manual?
Questions and answers