Advertisement
Kirby Morgan Dive Systems, Inc.
®
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
Fax: 805/928-0342
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
3) Use the included tie wrap P/N 520-038 to secure the
communications assembly to the mask. Position the end
or termination of the tie wrap so it won't be touching the
diver's face.
If the mask strap is installed, ensure the earphone wires
are routed on the inside of the strap NOT THE OUTSIDE.
4) Bend the lens body away from the jaw frame and
route the longer earphone wire across the front of the
mask. Ensure the wire is pushed down into the gap found
between these two parts of the mask. When the mask is
released the wire should fit snugly into the groove.
© MMXX Kirby Morgan Dive Systems, Inc. All Rights Reserved
Document #200821001
Page 2 of 4
Advertisement
