Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX
Error Message
Probable Cause
A stitch other than the buttonhole, bar tack or darning stitch was
selected and the start/stop button was pressed while the buttonhole
lever is lowered.
The buttonhole, bar tack or darning stitch was selected and the start/
stop button was pressed while the buttonhole lever is raised.
The start/stop button, reverse/reinforcement stitch button or thread
cutter button was pressed while the presser foot was raised.
You tried to combine more than 70 decorative stitches, satin stitches,
cross stitches or combined utility stitches.
The memory is full and the stitch or pattern cannot be saved.
You pressed the back key or the utility stitch key or the embroidery key
while a pattern was selected.
You changed the stitch pattern settings, and then tried to save them by
pressing the manual memory key.
You tried to select an embroidery pattern or change the layout when
the needle was down.
The machine is turned on while the needle is lowered and the
embroidery unit is attached.
This message is displayed when the embroidery unit is trying to
initialize while the embroidery foot is lowered.
When 13 or more patterns are in "Removable Disk", a pattern was
being retrieved.
Retrieving the pattern
The reverse/reinforcement stitch button, needle position button or
thread cutter button was pressed while the bobbin winder shaft is
moved to the right.
A pattern is being stored.
The start/stop button or reverse/reinforcement stitch button was pressed
when no pattern is selected.
Bobbin thread has run out.
Little bobbin thread remains.
188
Advertisement
Table of Contents
