Inserting A Piping - Brother NV1200 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES
CAUTION
● After adjusting the needle position, slowly
turn the balance wheel toward you and
check the needle does not touch
(counterclockwise) the presser foot. If the
needle hits the presser foot, the needle
may bend or break.
g Securely tighten the positioning screw with a
screwdriver.
a Positioning screw
h Topstitch around the zipper.
1
2
a Stitching
b Right side of fabric
c Basting stitching
d End of zipper opening
CAUTION
● When sewing, be sure that the needle
does not touch the zipper, otherwise the
needle may bend or break.
i Remove the basting stitching.
100
3
4

Inserting a piping

a Place the piping between two fabrics inside
out, as shown below.
a Fabric
b Piping
c Fabric
b Refer to the steps of attaching the adjustable
zipper/piping foot on the previous page.
Sew along the piping.
c
d After sewing, turn them over.
1
2
3