Status Light States - Cardo Systems Scala-rider Q2 User Manual

SETUP AND CONFIGURATION | SUPPORT | NOTICES |

STATUS LIGHT STATES

None
Alternating Red/blue flashes
Rapid Red flashes
1 blue flash every 3 seconds
2 blue flashes every 3 seconds Call being initiated or in
1 red flash every 3 seconds
2 red flashes every 3 seconds
Solid red
WORKING WITH THE FM RADIO
Your headset is equipped with a high-quality FM Radio receiver. This
section explains how to enjoy the functions of the FM Radio.
The scala-rider Q2 enables you to listen to FM Radio while you are
not receiving audio from another audio source.
While listening to the radio, you do not have to worry about missing
any calls, as the headset automatically mutes the FM Radio and
switches to Bluetooth headset operation when an incoming call is
received, or when you decide to initiate a call. When the conversation
is over, the headset automatically tunes back in to the FM Radio.
Turning the FM Radio On
While no call is on the headset (either mobile phone call or Intercom
call), press and hold the MC Button on your headset for three seconds
QGQ2_A5_021.indd 9
Headset is off
Mobile phone/GPS Pairing mode
Intercom Pairing mode
Standby – No call is in progress
progress / FM Radio ON
Battery is low
Call being initiated or in
progress / FM Radio ON and
battery is low
Headset is being charged
to turn on the radio. The radio tunes in to the last radio station you
were listening to. With some phones you should wait a few seconds
after ending a call before turning on the Radio.
Turning the FM Radio Off
While the radio is turned on, press and hold the MC button for three
seconds to turn the Radio off.
Switching Preset FM Radio Station
There are six pre-set Radio stations available on your scala-rider Q2.
While the Radio is on, tap the MC Button to cycle between saved
stations.
Searching for a New FM Radio Station
While the Radio is on, press and hold the Volume Up or Volume
Down Button for three seconds or until you hear the next station on
your headset.
Pressing Volume Up will search upwards (higher frequency). Pressing
Volume Down will search downwards (lower frequency). Once a
station is found, searching stops and you can hear the station.
To save this station, refer to the following section.
To continue searching, press the Volume Up or Volume Down Button
again for three seconds.
You may still continue to listen to the current unsaved station.
Pressing the MC Button in this case will switch to the next saved
station.
Saving an FM Radio Station
The FM Radio is equipped with a memory capacity of six stations.
• Select the station you wish to replace by tapping the MC
button until you find the station you want to replace.

scala-rider Q2™ |
2/19/08 1:52:06 PM