Cardo Systems Q-Line Audiokit Installation Manual

CONTENTS
1 2 3
Audio Kit for
6 7
Qz, Q1 and Q3
8 9
10 11
12 13
Noise canceling Speaker Jack6 Corded
1 5
microphone Microphone
(*Only with Q1/Q3)
2 Hybrid mic
Installation Guide 7 Replacement mic sponges
3 Release Tab
Allen wrench
Speakers 8
4
English - Chinese
ATTACH THE SCALA RIDER AUDIO KIT TO YOUR HELMET OPTION B: USING THE GLUE PLATE
4 Glue the Audio Kit onto your helmet when the standard Back
Attach the scala rider Plate method cannot be used. Choose which of the2 glue plates
Audio Kit to your helmet is most suitable for your helmet.
with the standard While we have no reason to believe that the gluing option
might negatively affect any helmet, Cardo does not assume
Backplate using the
any responsibility, irrespective of its nature and circumstances.
following instructions The Glue Plate is offered as an option that you may use at your own risk and subject to renouncement of any
5
future claims.
Remove the Back Plate by taking out both screws
1
Use the Alcohol pad to clean the exact spot on the helmet
2
Peel off protective backing sheet
3
OPTION A : USING THE BACK PLATE
Press here for 15 seconds
4
Allow the glue to dry for 24 hours
Loosen both screws 5
1
Fasten both screws tightly
6
2 Push the back plate between
the helmet's outer shell and
inner padding
3 Tighten the screws
Alcohol pads
9
Speaker Booster
10
pads
11 Velcro pads
Glue plates
12
Hybrid mic clip
13
POSITIONING THE HYBRID MICROPHONE CHANGING THE MICROPHONE TYPE
1 Open the lining between the helmet's inner padding. Removing: Before changing
Use the Velcro pad to hold the Hybrid Microphone in the microphone, completely
place
. Attach the Microphone to the Velcro pad. remove the Audio Kit and
2 Adjust the location so that the microphone is located opposite the center of your mouth. backplate from the helmet.
Attaching: Replace the
screws to reattach the
backplate to the Audio Kit
before reassembling on the
helmet and fully tightening
the screws.
PLACING THE SPEAKERS
For best clarity, place speakers directly opposite
and close to the ears. Helmets with deep recesses
may require padding to bring the speakers closer
for ideal positioning. Optional speaker booster
pads are provided for this purpose.
To use, place the speaker booster pad between the
Velcro pad in the helmet cavity and the speaker.
1 Attach Velcro pads to inside of Helmet.
Cross the long speaker wire over the center of
2
the helmet to enhance FM radio reception.
Using two speakers inside the helmet may be
prohibited in certain jurisdictions. If this is the case,
position both speakers on one side of the helmet.
POSITIONING THE CORDED MICROPHONE
Attach Velcro to inside front of helmet
The Corded Microphone can be used with Full
face helmets only (not Modular helmets).
Some helmets with air vents may require the mic
to be repositioned if mic audio is affected.
REPLACING THE CORDED MICROPHONE SPONGE

A replacement corded microphone sponge is
www.cardosystems.com
provided for future use should you need it.
NOTE: The wires to the microphone are delicate. Avoid touching them.

Pinch and pull existing microphone sponge
1 support@cardosystems.com
Carefully remove the existing sponge.
2
Remove protective backing sheet from replacement sponge 
3
Carefully attach the new sponge to the microphone
4 USa & Canada: 1-800-488-0363
International: +49 89 450 36819