Installing The Device - Dometic CE99-DF Installation And Operating Manual

Hobs and Combinations
6

Installing the device

!
WARNING! Health hazard
Assembly and installation of the device must only be carried out by
specialists. Incorrect assembly and installation can result in serious
hazards due to the escape of gas.
For proper operation of your cooking device:
• The cabinet must be
– properly constructed.
– squared to the countertop and cabinet face
• The opening in cabinet must be
– level from side to side and front to rear
• The cabinet opening must be constructed so that no combustible material can be
placed next to the cooktop sides.
• The maximum depth of cabinets installed above the cooking top must be 13 in
(330 mm).
• The device area has to kept clear and free from combustible materials, gasoline
and other flammable vapors and liquids.
• The flow of combustion and ventilation air must not be obstructed.
• Leak testing of the device shall be conducted according to the manufacturer's
instructions.
6.1 Selecting the installation location
When selecting the installation location, observe the following instructions:
• Consider the volume of air required for combustion (chapter "Technical data" on
page 26).
• During operation, there must be air vents with a cross-section of at least 23.25 in²
2
(150 cm ) in the installation room.
• Make sure that minimum distances (fig. 2, page 4) are observed.
• Ensure that there are no drafts at the installation location.
EN
Installing the device
19