Changing The Pattern Length - Brother N5V Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES
d Press or (Stitch width keys) until the
desired density is selected.
Select for sparse stitching or select
compact stitching.
e Press (OK key) or
The initial stitch screen appears again, and
the stitching density is changed.
CAUTION
● If the stitching density is too compacted,
depending on the needle, the stitches may
be bunched together, causing the needle
to break.

Changing the pattern length

The length of one part of a satin stitch can be set to
one of five sizes.
a Select a satin stitch (No. 32–47 of
selected with
b Press (Settings key) in the operation
panel.
The settings screen appears.
124
for
(Cancel/clear key).
,
).
c Press or (Stitch length keys) until
is displayed.
The screen for changing the length of a satin
stitch appears.
d Press or (Stitch width keys) until the
desired ratio is selected.
The length can be set within the range of
and .
• Press to reduce the length. If the key is
pressed while the smallest setting (×1) is
displayed, a beep sounds.
• Press to increase the length. If the key is
pressed while the largest setting (×5) is
displayed, a beep sounds.
The satin stitch length is changed.
e Press (OK key) or
key).
The initial stitch screen appears again.
(Cancel/clear