Before First Use - Atag VA63111ST User Manual

22
dicators of buttons
and start to flash.
3.
Press button
• The indicators of buttons
and go off.
•
The indicator of button
tinues to flash.
• The display shows a number and the
letter C. Each number is related to a

BEFORE FIRST USE

1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to "Setting and
starting a programme".
2. Press and hold, at the same time, but-
ton and button
, ,
.
,
con-
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
until the in-
different colour (0C = TimeBeam is
deactivated).
4.
To set a colour, press button
again and again to go through the menu
of colours. The different colours show
on the kitchen floor.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
dicators of buttons
and start to flash.
3. Press button
• The indicators of buttons
and
• The indicator of button
to flash.
• The acoustic signals operate, e.g. five
intermittent acoustic signals = level 5.
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
, ,
.
,
go off.
continues