Description - Siemens SINUMERIK MCP-S Series Equipment Manual

Operator control and display elements
3.3 Interfaces
Note
Warning for areas subject to NEC or CEC:
Safety notice for connectors with Ethernet marking:
A Ethernet or Ethernet segment, with all its associated interconnected equipment, shall be
entirely contained within a single low-voltage power distribution and within a single building.
The Ethernet is considered to be in an "environment A" according IEEE802.3 or "environment 0"
according IEC TR 62102, respectively.
Never make direct electrical connection to TNV-circuits (Telephone Network) or WAN (Wide Area
Network).
Pin assignment
The pin assignments of the interfaces can be found in Chapter "Connecting" > "Interfaces"
(Page 33).
Power supply connectors
Connection type
Connection screw
Operating tool
Specified tightening torque
Conductor cross-section min./max.
Solid
Finely stranded
With ferrule with collar DIN46228/4
With ferrule DIN46228/1
AWG cables, solid or stranded
3.3.2

Description

Switch S1
MCP set up as PN
Table 3-1
See Table "Settings of switch S1"
The two switches S1-9 and S1-10 must be set to "on" for the PN functionality.
20
General switch S1 setting
1-8
Strain-relief clamp connection
M2.5 screw with cross-slot
Screwdriver blade 0.6x3.5, PH0, PZ0 (DIN
5264, ISO 8764/2-PH, ISO 8764/2-PZ)
Nm 0.4 ... 0.5
mm² 1.3 ... 3.3
mm² 1.3 ... 3.3
mm² 1.3 ... 2.5
mm² 1.3 ... 3.3
AWG 12 ... 16
9 10 Meaning
on on PN
off off IE (default)
Equipment Manual, 07/2020, A5E50324729B AA
ONE MCP Part 1: MCP xxxx