Vitek VT-1300 Instruction Manual page 6

Note: During the first operation some foreign smell
and a small amount of smoke from the heating element
is possible, it is normal.
– Insert the power plug into the mains socket. Use the
– The nozzle (3) allows directing a narrow air flow of high
"Cool air" supply
This model has a cool shot button for fixing your hair.
Press and hold down the cool shot button (2) «
it enables to keep the created style.
– After unit operation, switch the hairdryer off by setting
Overheating protection
Overheating protection switches the hairdryer off if the
outgoing air flow is too hot. If the hairdryer switches off
during operation, set the operation mode switch (1) to
the "0" position, unplug the hair dryer and make sure that
the inlets and outlets are unblocked. Let the hairdryer cool
down for 5-10 minutes and switch it on again. Do not block
the air inlets during the hairdryer operation and keep your
hair from getting into the air inlet grid (4)
CLEANING AND CARE
– The hair dryer is intended for household use only.
– Set the switch (1) to the position «0» and disconnect
– You may wipe the unit body with a damp cloth and
– Clean the air inlet grid (4) with a brush.
– Never immerse the unit into water or other liquids.
– Do not use abrasives and solvents to clean the unit body.
STORAGE
– Unplug the hair dryer if you are not using it.
– Let the hair dryer cool down after its usage, keep the
– Never wind the power cord around the hairdryer, as
T-1300_70x130.indd 6
ENGLISH
switch (1) to set the necessary operation mode.
intensity at a definite hair lock.
the switch (1) to the position «0», and unplug it.
the hair dryer from the mains.
then wipe it dry.
unit away from children in a dry cool place.
this can damage the cord. Handle the power cord with
6
» –
8/22/19 2:37