Vitek VT-1300 Instruction Manual page 3

HAIR DRYER VT-1300
The hair dryer is intended for hair drying and styling.
DESCRIPTION
1.
2.
3.
4.
5.
ATTENTION!
– Do not use the unit near water in bathrooms, showers,
– After using the hair dryer in a bathroom, disconnect
– For additional protection you can install a residual cur-
SAFETY MEASURES
Before using the electrical unit, read this instruction
manual carefully and keep it for future reference.
Use the unit for its intended purpose only, as specified
in this manual. Mishandling of the unit may lead to its
breakage and cause harm to the user or damage to his/
her property.
•
•
•
•
•
•
•
T-1300_70x130.indd 3
Operation mode switch (0-1-2-3)
«Cool shot» button
Nozzle
Air inlet grid
Hairdryer handle
swimming pools etc.
the power plug from the mains socket, as water close-
ness is dangerous even if the unit is switched off.
rent device (RCD) with nominal operation current not
exceeding 30 mA into the bathroom mains; contact
a specialist for installation.
Before switching the unit on, make sure that the mains
voltage corresponds to the unit operating voltage.
Never leave the operating unit unattended.
Do not switch the unit on in places where aerosols are
sprayed or highly flammable liquids are used.
Hair spray should be applied only after hair straight-
ening is finished.
Always unplug the unit immediately after usage and
before cleaning.
When unplugging the unit, pull the plug but not cord.
Do not touch the unit body and the power plug with
wet hands.
ENGLISH
3
8/22/19 2:37