Disconnecting The Core Processor From The Tow Vehicle; Vehicle - Toro ProCore Processor Operator's Manual

1. Storage pin
2. Front hole (core processor
disconnected from tow

vehicle)

Important: When changing tow vehicles or tractors,
make sure that the hydraulic fluids are compatible with
the core processors. If the fluids are not compatible,
remove any fluid remaining in the core processor.
6
Disconnecting the Core
Processor from the Tow
Vehicle
No Parts Required
Procedure
1. Remove the storage pins from the rear hole position
(Figure 16).
2. Slowly lower the processor until it comes to rest on the
rear roller and tires.
3. Install the storage pins into the front hole position
(Figure 16).
4. After the storage pins are installed, turn off the tow
vehicle.
Figure 15
3. Rear hole (core processor
connected to tow vehicle)
1. Storage pin
2. Front hole (core processor
disconnected from tow
vehicle)
5. Lower the jack to the ground to stabilize the machine
(Figure 17).
1. Jack
6. Move the hydraulic-lift lever back and forth to remove
pressure from hydraulic lines.
7. Disconnect the hydraulic hoses from the tractor.
8. Remove the remote control from the vehicle.
9. Wind the hoses and cable onto the harness mount for
storage.
10. Remove the lynch pin and hitch pins securing the pitch
control link.
Note: You may need to slightly raise the aerator to
remove the hitch pins.
11. Remove the pitch control link.
12. Remove the lynch pin and hitch pins securing the
tow-arms to the aerator.
Note: You may need to slightly raise the aerator to
remove the hitch pins.
16
Figure 16
3. Rear hole (core processor
connected to tow vehicle)
Figure 17