Removing, Activating, And Charging The Battery - Toro ProCore Processor Operator's Manual

Important: Refer to
Special Instructions for Workman
and other utility tow vehicles (tractors) (page 21)
special operating instructions for the Workman and
other utility tow vehicles (tractors).
1
Removing, Activating, and
Charging the Battery
Parts needed for this procedure:
A/R Electrolyte (not supplied)
Procedure
1. If the battery is not filled with electrolyte or activated,
bulk electrolyte with 1.260 specific gravity must be
purchased from a battery supplier and added to the
battery.
DANGER
Battery electrolyte contains sulfuric acid
which is a deadly poison and causes severe
burns.
• Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber
gloves to protect your hands.
• Fill the battery where clean water is always
available for flushing the skin.
2. Remove the strap securing the battery cover to the
for battery box
1. Battery box
2. Battery cover
3. Remove the cover and lift the battery out of the battery
box.
4. Clean the top of the battery and remove the vent caps
(Figure
5. Carefully fill each cell with electrolyte until the plates
are covered with about 6 mm (1/4 inch) of fluid
5).
11
(Figure 3).
Figure 3
3. Strap
4).
Figure 4
(Figure