Storage - Toro ProCore Processor Operator's Manual

Storage

Note: Let the engine cool before storing it and do not store
it near a flame.
1. Wash the brush housing and chopper with water. Turn
the key in the ignition switch to the O
increase speed until the Chopper rotator is engaged.
Stand to 1 side at rear of machine and spray water into
spinning chopper until clean.
2. Check all fasteners and tighten as necessary.
3. Grease all grease fittings and wipe off excess lubricant.
4. Check the condition of the brush and blades and
replace as required.
5. Service the air cleaner; refer to
Cleaner (page 35).
6. Grease and oil the machine; refer to
Bearings and Bushings (page
7. Change the crankcase oil; refer to
Oil (page 36).
8. Check the tire pressure; refer to
Pressure (page 26).
9. Charge the battery; refer to
40).
10. Before disconnecting from the tow vehicle, lower the
core processor to the ground, install the storage pins
in the front holes, and then remove the hydraulic and
mechanical connections. This ensures that the core
processor remains stable when you disconnect it from
the tow vehicle.
position and
N
Servicing the Air
Greasing the
34).
Servicing the Engine
Checking the Tire
Servicing the Battery (page
45