Table of Contents
Advertisement
3
Mounting the Jack Stand
Parts needed for this procedure:
1
Jack stand
1
Jack-stand tube
Procedure
One-Pass Hitch
1. Remove the bolt and nut securing the tow bar to the
front of the core processor
2. Remove the tow bar.
1. Tow bar
2. Bolt
3. Insert the jack-stand tube into the tow bar mounting
hole
(Figure
8).
(Figure
7).
Figure 7
3. Nut
1. Tow bar mounting hole
2. Bolt
3. Jack-stand tube
4. Rotate the tube until the holes line up with the holes in
the core processor.
5. Using the bolt and nut previously removed, secure the
tube to the core processor
6. Slide the jack stand onto the jack tube, align the
mounting holes, and secure with the lynch pin
8
and
Figure
9).
13
Figure 8
4. Jack stand
5. Nut
(Figure
8).
Figure 9
(Figure
Advertisement
Table of Contents
