Lubrication; Greasing The Bearings And Bushings - Toro ProCore Processor Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
Lubricate the 18 core processor grease fittings regularly with
No. 2 lithium grease. Lubricate the chopper, rear roller and
rotating corner bearings immediately after every washing.
1. Lubricate the following grease fittings:
•
Tow frame (2); refer to
•
Lift cylinder (2); refer to
•
Lift axle (2); refer to
•
Jack shaft (2); refer to
•
Chopper assembly (2)
•
Rotating corner (2)
•
Pickup brush (2)
•
Rear roller (2) Figure
Figure 38
Figure 39.
Figure 38 and Figure
Figure 38.
Figure 41.
Figure 42 and Figure
Figure 42 and Figure 40.
Figure 42 and Figure 40.
40.
41.
40.
34
Figure 39
Figure 40
Figure 41