Table of Contents
Advertisement
2.4.6 Restricting Wireless Access
ACL
ACL modes
Adding a new ACL entry
Removing an ACL entry
E-DOC-CTC-20041126-0014 v3.0
The Access Control List (ACL) enables you to allow/deny access to your wireless
network for specific wireless clients.
Following modes are supported:
Off:
All new stations are allowed to access the SpeedTouch™716g WLAN.
On in Allow mode
Only stations that are listed in the ACL are allowed to access the
SpeedTouch™716g WLAN.
On in Deny mode
All stations that are
not
SpeedTouch™716g WLAN.
To add a new MAC address to your wireless MAC address filters:
1
Open the SpeedTouch™ web pages.
For more information, see
Pages" on page
2
Browse to Wireless > Access Control.
3
Click View Access Control List.
4
The Wireless Access Control List page appears:
Click Add.
5
Enter the MAC Address of the wireless device you want to allow in the MAC
address of wireless adaptor field:
Click Apply.
6
The SpeedTouch™716g adds the entry to the Access Control List:
To delete the a MAC address from the list:
1
On the Wireless Action Control List page, click
2
The SpeedTouch™716g prompts you to confirm your choice. Click Yes.
3
The entry has been deleted.
SpeedTouch™ Local Networking Setup
listed in the ACL are allowed to access the
"5.1 Accessing the SpeedTouch™ Web
44.
.
Chapter 2
33
Advertisement
Table of Contents
