Table of Contents
Advertisement
Chapter 2
SpeedTouch™ Local Networking Setup
The SpeedTouch™
Ethernet switch
Wiring procedure
Verifying Ethernet
connectivity
Internet connection
16
2.1 Ethernet Connection Setup
The SpeedTouch™ four-port 10/100 Mbps auto-sensing MDI/MDI-X Ethernet switch
allows you to create a local Ethernet network of up to four devices, without needing
extra networking devices or to expand an existing 10 or 100Base-T Ethernet
network.
Use the yellow cable to connect the SpeedTouch™ to your computer or hub (in case
you want to extend your network).
If an external hub or switch is used for wired Ethernet networking, please
follow the installation instructions supplied with the hub for connections
and Ethernet cabling.
If the Ethernet LED of the corresponding port is solid green or flashing, you are
successfully connected to the SpeedTouch™ Ethernet network.
To prepare the SpeedTouch™ for accessing the internet, continue with
setup
"3 Configuration" on page
37.
E-DOC-CTC-20041126-0014 v3.0
Advertisement
Table of Contents
