Advertisement
Available languages
Available languages
ENGLISH
EMax34IN, EMax38IN &
EMax42IN only)
When the grass collection box is full you can compact the
grass in the collection box. You can determine how full the
grass collection box is by looking through the clear grass
(10).
Release the on/off switch (2).
u
Using your right foot, press the grass compaction lever
u
(29) all the way down until it locks into place.
Note: The grass in the collection box is now compressed into
the rear of the box. You may continue mowing until the grass
collection box becomes full.
(EMax34IN,EMax38IN & EMax42I only)
Release the on/off switch (2).
u
Remove the grass collection box (9).
u
Empty the contents from the front of the box.
u
Place the grass collection box on the ground and pull in
u
and hold the grass compaction lever release button (30).
Lift the grass compaction lever (29) into the vertical
u
position and release the grass compaction lever release
button (30).
Empty the contents from the rear of the box.
u
Emptying the grass collection box (EMax34SN only)
When the grass collection box is full you should empty the
grass in the collection box.
Release the on/off switch (2).
u
Remove the grass collection box (9).
u
Empty the contents from the box.
u
Carrying the mower
Warning! Ensure the blade has completely stopped and
disconnect the appliance from the mains.
The mower can be carried using the convenient carry
u
handles (11).
Hints for optimum use
If the grass is longer than approximately 10 cm, make two
u
cuts to obtain a better
of cut, then use a low or medium height of cut.
In order to achieve optimum results, only mow dry grass.
u
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Warning! Before proceeding, remove the plug from the
socket.
4
(Original instructions)
First mow at maximum height
Problem
Possible Cause
Machine fails to
Power turned off
operate
Fuse faulty/blown
Grass too long
Thermal cut out
activated
Machine functions
Thermal cut out
intermittently
activated
Machine leaves
Height of cut too low
Cutting blade blunt
motor labours
Underside of machine
clogged
Blade
down
Possible solution
Turn power on
Replace fuse
Increase the height of
cut and move machine
to shorter grass to start
Allow motor to cool and
increase height of cut
Allow motor to cool and
increase height of cut
Increase height of cut
Replace the blade
Check underneath the
machine and clear out
as necessary (always
wear heavy duty
gloves)
upside
blade correctly
Advertisement
